Some car models have serious design errors that pose problems to the car drivers when they drive the cars. The only way to avoid such troubles is to send the car for the repair services when they notice that problems are becoming a trouble in driving the car. Swirl flap is a small butterfly shaped part of the car that is fitted into a part which is just in front of the cylinder of many automobiles. These are helpful in enhancing the performance of the car engine by improving the combustion at very low rate. It partially prevents the airflow to go through intake manifold. It is because of this that the air moves at higher velocity and enables better mixing or swirling of air for better combustion. Swirl flaps are found in all the top branded cars despite it is the diesel car or gas car. Due to the repetitive functioning, it is at higher risk of getting damaged. Visit www.pmwltd.co.uk to know the Swirl flap issue.
Common issues with Swirl flap
Problems which are very common with swirl flaps are that they can get struck open, closed or get broken. Poor design of the swirl flaps are at higher risk to damage. Another problem that is common with the swirl flaps is that small screws that hold the flap with shaft either get loosen or it gets broken that makes it no more functional.
These are the possible problems that can happen in the car. So, there is a need to get the swirl flap checked and repaired by the professionals. Damage to the swirl flaps can also be caused due to the wearing and tearing of the parts of the car or car accident.
Fixing the trouble
There are lots of reliable car repair companies that repair it very easily. You need to take the services of the reliable car repair company for the effective job done. The problem of swirl flaps can also be resolved when you get the car for MOT test. In that test, your car will undergo various test and inspections in which the damaged swirl flap can be identified and replaced.
For fixing the swirl flap related trouble, there is a need to remove the inlet manifold shaft and clean it thoroughly with steam. A small valve is attached that is cleaned with the cleaning tool. Broken or damaged flap is then replaced with the new one and fixed back again on the shaft. Now, inlet manifold gasket is also fitted to correct the wrong design.